Description

Microprocessor and addressable siren (with short-circuit isolator) that is installed as an extra element of the loop. The siren is made of heat-resistant red ABS.

It is a module with a single programming function in terms of timing and combination of sensors that activate it. This siren is configured as a relay that acts as a siren.

The SIRAYL variant also emits light signals. The fact that these sirens specifically emit light does not affect the planning of the plant. For this reason these devices are programmed centrally as if they were the SIRAY reference.

The standard configuration of the siren sound is shown in figure 8A according to EN 54-3 (acoustic device).

You can change the selection of tone and light signal, but this operation affects the energy consumption of the siren, and then the consumption of points of the device. Figure 8B shows an equivalence table for tone selections (standard 95 dB-1 m and maximum sound intensity 105 dB-1 m) and visual signal (W-2,4-2,3/7,5). You can perform accurate calculations with the loop element capacity calculation software.

The internal wiring and positions of other micro-switches shall not be changed from those selected by the manufacturer by default.

Characteristics

    24V - 35V power supply with polarity
    1 mA standby power consumption
    Alarm consumption of 5-50 mA
    circuit isolator
    Operating temperature from -10 ºC to +55 ºC
    Dimensions: SOMEBODY 95 x 107 mm
    Standard: EN54-3
    Degree of protection IP65
    Sound intensity of 95/105 dB - 1m